Kennedy Wire Rope & Sling, Co.

[PRODUCTS PAGE, HOME]
Catalog provided courtesy of The Crosby Group, Inc.

	Hook Latches
Page 117

HOOK LATCH KIT

WARNING AND APPLICATION
INSTRUCTIONS

latch.jpg (10959 bytes)
SS-4055

WARNING

Loads may disengage from hook if proper procedures are not followed.
A falling load may cause serious injury or death.
See OSHA Rule 1926.550(g) (4) (iv) (B). A hook and this style latch must not be used for lifting personnel.
Hook must always support the load. The load must never be supported by the latch.
Read and understand these instructions before using hook and latch.

Important Safety Information -
Read and Follow

Always inspect hook and latch before using.
Never use a latch that is distorted or bent.
Always make sure spring will force the latch against the tip of the hook.
Always make sure hook supports the load. The latch must never support the load. (See Figure 1 & 2)
When placing two (2) sling legs in hook, make sure the angle between legs is small enough and the legs are not tilted so that nothing bears against the bottom of the latch. (See Figure 3 & 4)
Latches are intended to retain loose sling or devices under slack conditions.
Latches are not intended to be an anti-fouling device.

Right

Wrong

Right

Wrong

Figure 1

Figure 2

Figure 3

Figure 4

IMPORTANT - Instructions for Assembling SS-4055 Latch on Crosby Hooks

Step 1

Place hook at approximately a 45 degree angle with the cam up.

Step 2

Position coils of spring over cam with tines of spring pointing toward point of hook and loop of spring positioned down and lying against the hook.

Step 3

Position latch over tines of spring with ears partially over hook cam. Swing latch to one side of hook, point and depress latch and spring until latch clears point of hook.

Step 4, 5, & 6

4. Line up holes in latch with hook cam.
5. Insert bolt through latch, spring, and cam.
6. Tighten self-locking nut on one end of bolt.

	Copyright © 2003 The Crosby Group, Inc. All rights reserved